Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10.1.e - Adjusting traction help (only
for models without traction)
(Fig. 14)
The function of the hand wheel (79) is to in-
crease / decrease the ground pressure of the
brush in order to facilitate thrusting forward
the machine.
-
Turning the hand wheel (79) clockwise
will decrease traction adjustment and
conversely it will increase it.
10.1.f - End of use and switching off
(Fig. 9-13)
-
At the end of the cleaning operations, be-
fore turning off the machine, turn off the
water supply, the chemical agent supply
(if any) and the brush rotation by operat-
ing the buttons (51 Fig. 9), (49 Fig. 9) and
(52 Fig. 9).
-
Lift up the brush by pressing the pedal
(19 Fig. 15) as far as it will go, fitting it in
the designated slot.
-
Continue with the aspirator inserted to
aspirate all the liquid on the floor, then
turn off the aspirator by pressing the but-
ton (50 Fig. 9).
-
Lift the squeegee (11 Fig. 15) by lifting
the lever (3 Fig. 15).
WARNING:
Always lift the wiper and the end piece
after finishing the cleaning operations be-
cause this avoids the deformation of the
rubber blades and of the brush hairs.
-
Press the button (45 Fig. 9) to turn off the
machine.
WARNING:
If the machine will not be used for a few
days, it is recommended to disconnect
the plug (35 Fig. 7-8) from the relative
socket.
10.1.g - Maximum recovery tank wa-
ter level alarm (Fig. 18)
If during the use of the machine the vacuum
stops and the display shows the symbol "
" this means that the level of the liquid in
the recovery tank has reached its maximum
level.
Go to the water drainage station and drain
the recovery tank as shown in the relative
paragraph.
-
In order to disable the alarm, stop and
restart the machine.
NOTE:
For the proper operation of the level sensors
it is required to properly clean the inside of
the tank (14 Fig. 18).
ENGLISH - 14
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Publicidad
Capítulos
Tabla de contenido
