Battery Charger And Digital Instrument Configuration - Ghibli & Wirbel ROUND 45 TOUCH Instrucciones De Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
metres, then turn off the aspirator and
stop the machine.
- Check the incidence of the rubber (60)
blades.
Fig. A = too low
Fig. B = too high
Fig. C = correct position
- Use the grey knob (64) for adjustment,
turning it anticlockwise to increase the
incidence and in the other direction to de-
crease it.
12.1.n - Battery charger and digital
instrument configuration (Fig.
25)
WARNING:
The machine leaves production with a
standard configuration for operation with
"Sonnenschein" gel batteries.
WARNING:
Disconnect the battery plug from the
socket.
- Remove the cover (61) by unscrewing
the screws (62).
Standard configuration with Sonnen-
schein gel batteries
- Remove the cap (66) located under the
batter charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "A".
It is possible to modify the configuration as
follows:
Configuration for gel batteries which are
not Sonnenschein version
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "B".
Configuration for acid batteries
- Remove the cap (66) located under the
battery charger (16).
- Position the switches (DP1 and DP2) as
shown in figure "C".
ENGLISH - 19