Fixing The Limit Switch Brackets - Vimar Elvox ESM7 ACTO 404D Manual Para El Conexionado Y El Uso

Fig. 18
Fig. 21
Securing the limit switch brackets
Manually unlock the gear motor, move the gate to the point where it is completely open, secure the bracket of the limit switch A so that the magnet matches
the sensor, move the gate to the point where it is completely closed, and secure the bracket of the limit switch B so that the magnet matches the sensor. After
testing, check the stopping point, the gate must stop approximately 1 or 2 cm before the mechanical stops.
N.B. The magnets fixed in the brackets must not be swapped over under any circumstances.
A
20
Fig. 19
1 m
m
Fig. 22
Chiusura Apertura
Fig. 24
Start of limit
switch reading
point
B
Fig. 20
1 m
m
Fig. 23
Fig. 25
EN