Basic Safety Aspects - Lucent Technologies LambdaUnite Manual De Seguridad

Basic safety aspects

............................................................................................................................................................................................................................................................
General safety
requirements
...............................................................................................................................................................................................................................................................
1 - 6
In order to keep the technically unavoidable residual risk to a minimum,
it is imperative to observe the following rules:
• Transport, storage and operation of the system must be under the
permissible conditions only.
See accompanying documentation and information on the system.
• Installation, configuration and disassembly must be carried out only
by expert personnel and with reference to the respective
documentation.
Due to the complexity of the system, the personnel requires special
training.
• The system must be operated by expert and authorised users only.
The user must operate the system only after having read and
understood this safety guide and the parts of the documentation
relevant to operation. For complex systems, additional training is
recommended. Any obligatory training for operating and service
personnel must be carried out and documented.
• The system must not be operated unless it is in perfect working
order.
Any faults and errors that might affect safety must be reported
immediately by the user to a person in responsibility.
• The system must be operated only with the connections and under
the environmental conditions as described in the documentation.
• Any conversions or changes to the system or parts of the system
(including the software) must be carried out by qualified Lucent
Technologies personnel or by expert personnel authorised by
Lucent Technologies.
All changes carried out by other persons lead to a complete
exemption from liability.
No components/spare parts must be used other than those
recommended by the manufacturer and those listed in the
procurement documents.
• The removal or disabling of safety facilities, the clearing of faults
and errors, and the maintenance of the equipment must be carried
out by specially qualified personnel only.
The respective parts of the documentation must be strictly
observed. The documentation must also be consulted during the
selection of measuring and test equipment.
• Calibrations, special tests after repairs and regular safety checks
must be carried out, documented and archived.
EN: Safety guide
365-374-138A4
Issue 1, November 2003