Meaning Of The Characters Shown On The Display Card Fig. 4 - FAS 480 BUDGET Manual Del Usuario

16
8.2

MEANING OF THE CHARACTERS SHOWN ON THE DISPLAY CARD FIG. 4

CHARACTER
0 =
1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
9 =
E
a =
N
d =
G
E =
L
F =
I
H =
S
P =
H
- =
EXPLANATION OF THE MEANING OF THE CHARACTERS OF THE TABLE
CHARACTER "1"
Character "1" appears when the control card is not able to communicate with the coin mechanism.
Control that the DIP-SWITCH DSW1 is correctly set. Otherwise:
1) Check that the coin mechanism has been correctly programmed.
2) Check the connection between the connector JP11 of the card and the coin mechanism.
CHARACTER "4"
Character "4" appears when the thermic relay of the column engine has tripped due to an over-heating of
the engine itself.
Attract by hand all the small solenoid magnets and check that the column rotates freely.
Otherwise:
1) Check the connection between the connector JP1 of the card and the thermic relay 1.
CHARACTER "5" (only in the vending machines BO)
Character "5" appears when the thermic relay of the engine for the withdrawal of bottles/cans has tripped
due to an over-heating of the engine itself.
Control that the withdrawal engine is not blocked.
Otherwise:
1) Check the connection between the connector JP1 of the card and the thermic relay 2.
CHARACTER "7"
Character "7" appears when the micro-switch of the delivery door is not pressed (the delivery door has
remained open).
Check that the delivery door closes correctly.
Otherwise:
1) Check the connection between the connector JP6 of the card and the micro-switch of the delivery door.
2) Check the integrity of the micro-switch of the delivery door.
CHARACTER "9"
Character "9" appears especially when a selection solenoid is not at rest.
Check that all the solenoids are at rest (small pistons re-entered).
Otherwise:
1) Check that the series of micro-solenoids make up a closed circuit on the connector JP5 of the card.
CHARACTER "d"
Character "d" appears during the sale when the small piston of the selection solenoid does not be attracted.
Check that the small piston of the solenoid of the carried out selection is not blocked or damaged.
Otherwise:
1) Check if the fuse on the card has burnt out.
2) Check the connection between the selection solenoid and the connector JP7 of the card.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
MEANING
NOT USED
INTERR. IN THE COMMUNICATIONS WITH THE COIN MECHANISM
NOT USED
FREE SALE (NOT CONTROLLED)
THERMIC RELAY ENGINE COLUMN 1 TRIPPED
THERMIC RELAY ENGINE COLUMN 2 TRIPPED (BO-FAS_DUO)
RELOAD CYCLE RUNNING
MICROSWITCH DELIVERY DOOR NOT AT REST
COIN MECHANISM INHIBITED (NOT CONTROLLED)
SOLENOIDS NOT AT REST OR MICROSWITCH SERIES NOT OK
SEL. BUTTON X ALWAYS PRESSED (NOT CONTROLLED)
SOLENOID X DOES NOT BE ATTRACTED (TX failure vend)
CYCLE OF SELF-TEST RUNNING
START PROGRAM EXECUTION (ONLY AT RESET)
REFRIGERATION UNIT SECURITY ALARM ACTIVE
ERROR SOFTWARE
NORMAL FUNCTIONING
480 Budget - Issue 00