Descargar Imprimir esta página

To Start The Engine - Craftsman 580.326310 Instrucciones De Uso

Ocultar thumbs Ver también para 580.326310:

Publicidad

Idiomas disponibles

Idiomas disponibles

To Start The Engine
Disconnect all electrical loads from the generator.
NEVER start or stop engine with electrical devices
plugged in and turned ON. Follow start instruction
steps in numerical order:
1.
Make sure unit is on a level surface.
IMPORTANT:
Failure to start and operate unit on a
level surface will cause the unit not to start or shut
down during operation.
2.
Turn fuel valve to "On" position. Fuel valve handle
should be vertical (pointing toward the ground) for
fuel to flow.
Fuel Valve is shown
in the On position
3.
Place choke lever in "Choke" position.
4.
Set engine rocker switch to "On" position.
Engine Rocker Switch
is shown
in On position
5A. For electric
starting,
push and hold the start
switch in "Start" position until generator starts. To
prolong the life of starter components,
DO NOT
hold start switch in "Start" position for more than
15 seconds, and pause for at least 1 minute
between starting attempts.
START
*
If engine starts, proceed to step 7.
.
If engine fails to start, proceed to step 6.
NOTE: If battery is discharged, use manual starting
instructions.
5B. For manual starting,
grasp recoil handle and pull
slowly until slight resistance is felt. Then pull
rapidly one time only to start engine.
WARNING
When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pull rapidly
to avoid kickback.
NEVER
start
or stop engine
with electrical
devices
plugged
in and turned
on.
If engine starts, proceed to step 7.
If engine fails to start, proceed to step 6.
6.
Move choke lever to "Half" choke position, and
pull recoil handle twice.
If engine fails to start, repeat steps 5 thru 7.
7.
Slowly move choke lever to "Run" position. If
engine falters, move choke lever to "Half" choke
position until engine runs smoothly, and then to
"Run" position.
IMPORTANT:
If engine floods, place choke lever in
"Run" position and crank until engine starts.
WARNING
DO NOT touch
hot surfaces
and avoid hot exhaust
gases.
Allow
equipment
to cool before
touching.
Keep at least 5 ft. (152 cm) clearance
on all sides
of
generator
including
overhead.
Reflective
exhaust
heat may damage
fuel tank causing
fire.
Code of Federal
Regulation
(CFR)
Title 36 Parks,
Forests,
and Public
Property
require
equipment
powered
by an internal
combustion
engine
to have a spark
arrester,
maintained
in effective
working
order,
complying
to USDA
Forest
service
standard
5100-1C
or later
revision.
In the State of California
a spark
arrester
is
required
under section
4442
of the California
Public
resources
code.
Other
states
may have similar
laws.
NOTE: If engine starts after 3 pulls but fails to run, or
if unit shuts down during operation, make sure unit is
on a level surface and check for proper oil level in
crankcase. This unit may be equipped with a low oil
protection device. If so, oil must be at proper level for
engine to start.
10

Publicidad

loading