Publicidad
Idiomas disponibles
Idiomas disponibles
Your Craftsman generator requires some assembly
and is ready for use only after it has been properly
serviced with the recommended
oil and fuel.
if you have any problems
with the assembly
of
your generator,
please call the generator
helpline
at 1-800-222-3136.
Unpacking
the Generator
1.
Set the carton on a rigid flat surface.
2.
Remove everything from carton except generator.
3.
Open carton completely by cutting each corner
from top to bottom.
4.
Leave generator on carton to install wheel kit.
Carton
Contents
Check all contents against those listed below:
Main unit
Engine oil
Oil bottle funnel
Operator's manual
Wheel kit
Adapter cord set
If any parts are missing or damaged, call the
generator helpline at 1-800-222-3136.
install Wheel
Kit
NOTE: Wheel kit is not intended for over-the-road
use. DO NOT tow this unit with a motorized vehicle.
You will need the following tools to install these
components:
•
13mm wrench
•
Socket wrench with a 13mm socket
•
Pliers
•
Safety glasses
install the Wheel Kit as Follows:
IMPORTANT:
Installing the wheel kit must be
completed prior to adding any oil or fuel.
1.
Tip generator so that engine end is up.
2.
Slide axle through both mounting brackets.
3.
Place a wheel on each side as shown.
4.
Place a washer on axle and then place an e-ring
in axle groove.
5.
Install e-ring with pliers, squeezing from top of
e-ring to bottom of axle.
CAUTION
Always
wear
eye
when
6.
Repeat step 4 and 5 to secure second wheel.
7.
Tip generator so that engine side is down.
8.
Attach support leg with M8 x 20 mm cap screws
and M8 hex nuts.
9.
Return generator to normal operating position
(resting on wheels and support leg).
10. Raise handles and insert handle pins to move
generator.
Handle
Pin
Your unit may vary slightly
from that shown here
Support
Leg --
Axle
20 mm Cap Screw
Wheel
Flat Washer
E-Ring
Publicidad
