Publicidad
Idiomas disponibles
Idiomas disponibles
120 Volt AC, 20 Amp, Duplex
Receptacles
Each duplex receptacle is protected against overload
by a double pole rocker switch circuit breaker.
How to Use the Battery
Charger
Use battery charger jack to keep the starting battery
charged and ready for use. Battery charging should be
done in a dry location, such as inside a garage.
1.
Plug charger into unit's "12V DC Battery Charger"
jack, which is located on the start switch bracket.
Plug battery charger into a 120 Volt AC wall
receptacle.
FS..f
_
-_.
,
Use each receptacle to operate 120 Volt AC,
single-phase,
60 Hz electrical loads requiring up to
2,400 watts (2.4 kW) at 20 Amps of current. Use cord
sets that are rated for 125 Volt AC loads at 20 Amps
(or greater).
GENERATOR
ADAPTER
CORD SET
The generator comes with a 25' generator adapter
cord set designed to provide two sets of 120 Volt,
20 Amp outlets from one 120 Volt, 20 Amp duplex
receptacle.
\
2.
Unplug charger from unit and wall outlet when
generator is being started and while in operation.
3.
Keep charger plugged in when generator is not in
use to prolong battery life. The charger has a built
in float equalizer and will not overcharge battery,
even when plugged in for an extended period of
time.
IMPORTANT:
See "Battery Maintenance" on page 16
for additional information.
The maximum load on each outlet is 20 Amps. The
maximum total load on both black wire outlets or white
stripe wire outlets is 20 Amps.
NOTE: Follow all safety precautions when connecting
any extension cord or device to the generator.
12
Publicidad
