Display Alarms - VLX 1040S Manual De Instrucciones

At the end of charging with the
electronic battery charger, the
battery does not provide the
correct voltage (about 2.14 V
per element without load) and
only one or a few elements are
found to be discharged when
tested with a hydrometer
The electrolyte in the battery is
turbid
ACC / MAN : ACCelerator / MAN
Appears if the drive lever is pushed when starting or after an emergency reset.
The drive cannot be engaged until the lever is released.
POT : POTentiometer
This indicates a fault or breakage of the speed adjustment knob
Drive stops, release the drive lever and then activate it again.
If the problem persists, the knob may be broken.
Lim : Limitation
Appears when the MOSFET reaches the internal temperature limit.
Drive stops, release the drive lever and then activate it again.
If the problem persists, wait a few minutes to let the Mosfet cool down.
Hom : MOSFET thermal protector
• the battery charger has not
been installed correctly
• the battery charger is not
working
• one or more elements are
damaged
• The battery has reached the
end of the charging/discharging
cycles declared
manufacturer
• the battery has been recharged
with too high a current
• the battery has been charged
beyond the limit suggested by
the Manufacturer
11.

DISPLAY ALARMS

• taking the actual voltage
available at the socket into
account, make sure that the
connections of the primary of
the transformer inside the
battery charger are correct
(consult the battery charger
manual)
• make sure there is voltage
to the battery charger, that
the fuses are not blown and
that the current reaches the
battery; try charging with
another rectifier. If the battery
charger
contact the technical service
centre and indicate the serial
number
charger
• replace
elements if possible.
For 6 or 12 V single block
batteries, replace the entire
battery
• replace the battery
by the
• replace the battery
• replace the battery
ENGLISH
is not working,
of the battery
the damaged
25