Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12. CONNECT THE WIRING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Remove wiring cover from rough-in plate and set aside.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. Reinstall wiring cover.
13. FINISH THE DRYWALL BOX
Finish the drywall box. Check fitting with dry wall trim before mounting it to the hood.
14. MOUNT THE DECORATIVE FLUE COVER OR THE DRY WALL TRIM ON THE HOOD
The decorative flue cover AEIP Series and the dry wall trim ATDIP Series may have sharp edges. Be careful when
handling and installing these metal parts.
14.1I
NSTALLATION WITH
AEIP S
ERIES
Remove the protective plastic film covering the decorative flue
cover AEWP Series. Assemble the flue cover on top of hood
using (14) no. 8 x 3/8" screws (provided with decorative flue
cover). See illustration beside to locate mounting screws from
top of hood.
NOTE: Ensure edges fit perfectly before tightening completely
the mounting screws.
14.2I
NSTALLATION WITH DRY WALL TRIM
Remove the protective plastic film covering the dry wall trim
ATDPI Series. Assemble the dry wall trim on the top of the
hood using (14) no. 8 x 3/8" screws (provided with dry wall
trim). See illustration beside to locate mounting screws from
top of hood.
NOTE: Ensure edges fit perfectly before tightening completely
the mounting screws.
15. INSTALL THE HOOD
15.1I
NSTALLATION WITH DECORATIVE FLUE COVER
Assemble the hood assembly to the mounting brackets by aligning keyholes with
4 nuts previously installed in step 8 (2 nuts per side). While holding the hood,
remove one nut and install a washer (included in parts bag) on each pem
stud, then reinstall the nut and tighten it. See illustration beside.
15.2I
NSTALLATION WITH DRY WALL TRIM
Align hood keyholes with pem studs on brackets. Secure the hood to the brackets
using washers and nuts (included in parts bag). See illustration beside.
!
(INSTALLATION WITH DRY WALL TRIM ATDIP SERIES ONLY)
!
DECORATIVE
FLUE
ATDIP S
ATDIP S
WARNING
WARNING
COVER
ERIES
HD0233
AEIP S
ERIES
ERIES
- 10 -
M
OUNTING SCREWS LOCATION
HD0234
Publicidad
Tabla de contenido
