Weinmann CPAP 20e Descripción Del Aparato E Instrucciones De Manejo página 29

5. Check whether the pressure measurement tube is still correctly fitted in the up-
per part. If necessary reinsert it.
For hygiene reasons, we recommend that the plastic parts are replaced after a
maximum of two years use.
CLICK 2 drying
If water penetrates into the pressure line, then dry CLICK 2 as follows:
Caution!
The bellows must
CLICK 2 must not be connected to the therapy unit. Otherwise the unit
could be damaged.
2. Press the bellows together so that any moisture is blown out.
Caution!
Keep the bellows pressed in so that moisture is not sucked back in again.
3. Remove the bellows.
4. Repeat steps
6. Fit the upper and lower parts together such that
Marks
7. Remove the closure. The humidifier is now ready
1. Push the bellows included in the delivery, as illus-
only
be used for drying the humidifier. During drying
1. 3.
to two or three times.
the marks are aligned. Turn the upper and lower
parts against each other clockwise as far as they
will go.
for use again.
trated, onto the end of the pressure line at the
outlet connectors.
Hygienic preparation
EN
29