Installation Instructions
Dispose of Packing Materials
The packing materials for this appliance may be dangerous to children and must be kept away from
children and disposed of properly. Dispose the related packing materials according to the relevant
local regulations. Do not dispose packing materials together with other daily waste materials.
Remove Transport Bolts
Before using this washing machine, transport bolts
must be removed from the backside of
this machine. Please take the following steps to
remove the bolts:
1. Loosen all bolts with spanner and then remove.
2. Cover the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Select Proper Location
Before installing the washing machine, the location must be carefully selected based on the following
requirements.
• Rigid, dry, and level surface (if surface is not level, adjust the leg levelers accordingly (Refer to
Page 13, "Leveling the Washer").
• Avoid exposure of appliance to direct sunlight.
• Allow sufficient ventilation.
• Room temperature must be above 32°F (0°C).
• Keep far away from any heat sources such as coal or gas.
• Make sure the washing machine will not stand on power cord.
• Do not install the washing machine on carpeted floor or on top of a rug.
Connect Inlet Pipe
Connect the inlet pipe as indicated in the figure.
For models with a hot valve, connect the hot
valve to hot water tap.
12