Electrical Connection - Magic Chef MCSCWD20W Manual Del Usurio

Floor Drain System (Fig. D)
The floor drain system requires a siphon break that may
be purchased separately. The siphon break must be a
minimum of 28" ( 710 mm) from the bottom of the
washer. Additional hoses may be required.
Leveling the Washer
1. When positioning the washing machine, check if the
legs are closely attached to the cabinet. If not, turn
them to their original positions with hand or spanner
and tighten the nuts.
2. After positioning the washing machine, press the four
(4) corners on top cover of washing machine in
sequence. If the washing machine is not stable when
being pressed, this associated leg must be adjusted.
3. Ensure the position of the washing machine. Loosen
the lock nut with spanner and turn the leg by hand
until it contacts the floor. Press the leg with one hand
and fasten the nut closely to the cabinet with the
other hand.
4. After being locked properly, press the four (4) corners
again to ensure the legs have been adjusted
properly. If it is still unstable, repeat Steps 2 and 3.
5. Use a carpenter's level (on all four (4) sides) to
ensure the appliance is level.

Electrical Connection

• As the maximum current through the unit is 12A, when using the heating (dryer) function, please
make sure the power supply system (current, power voltage and wire) at your home meets the
normal loading requirements of this appliance.
• Connect the power to a socket which is correctly installed and properly grounded.
• Make sure the power voltage is identical to the machine's rating label.
• Power plug must match the socket and cabinet must be properly and effectively grounded.
• Do not use a multi-purpose plug, socket or extension cord.
• Do not connect and pull out plug with wet hands.
• When connecting and disconnecting the plug, hold the plug tightly by the base and then pull out.
Do not pull power plug forcibly or by the cord.
• If power cord is damaged or has any sign of damage, a replacement power cord must be
purchased from the manufacturer or service center for replacement.
• DO NOT OPERATE THE MACHINE WITH A DAMAGED POWER CORD.
• DO NOT ATTEMPT TO REPAIR A DAMAGED POWER CORD.
14