Troubleshooting - HURAKAN HKN-BCF3 Manual Del Usuario

EN
2. Remove the lower panel (B): to do this, unscrew clamping screws (C);
3. Clean the condenser fins (D);
4. After cleaning, reinstall and screw the panel.
5.

TROUBLESHOOTING

The information given below is intended to facilitate the identification and elimination of
malfunctions that may occur during the use of the device. Certain malfunctions can be
eliminated by user's own forces. To eliminate other malfunctions, please contact a
specialized service center.
Malfunction
The device
enabled
The device
functioning, but cooling
is insufficient
The cooling system is
not switched off
Ice in the evaporator
Intense noise
device operation
6. INSTALLATION
6.1. Packaging
Carry out transportation and packaging of the device relying only on the information
specified on the packaging, on the device itself and in this manual.
Packaging is made of cardboard and plywood. Packaging contains special signs that regulate
handling, transportation and storage in accordance with international standards.
46
Cause
No power
is not
Other
Too high room temperature
The
contaminated
The chamber door is not
is
closed tightly
Insufficient
volume
The condenser fan has
stopped
The evaporator fan has
stopped
Faulty thermal probe
Faulty control board
during
Sustained vibration
condenser is
refrigerant
Remedy
Check the power supply cable
Check the fuses
Check that the device is
properly connected
Contact the service center
Ventilate the room
Clean the condenser
Check the door seal
Contact the service center
Contact the service center
Contact the service center
Contact the service center
Contact the service center
Carry out the defrosting cycle
If the problem
contact the service center
Check whether the device
contacts foreign objects (both
outside and inside)
persists,