HURAKAN HKN-BCF3 Manual Del Usuario página 48

EN
- that the device completed at least one cooling/freezing cycle.
7. DISPOSAL
The device is marked in accordance with European Directive 2002/96/EC - WASTE
ELECTRICAL AND ELECTRIC EQUIPMENT (WEEE).
The proper disposal ensures the absence of potentially adverse effects on the environment
and health.
For more information on the device recovery, disposal and recycling, please contact the
respective local authorities that regulate such procedures.
8. MAIN FEATURES
This series of devices is designed for quick cooling and freezing in accordance with
international food safety standards.
4 types of cycles are maintained:
➢ cycles: Cy1, Cy2, Cy3, Cy4 are preset cycles that are most commonly used for handling
the device according to generally accepted standards. The user can select any cycle and
adjust it at its own wish and requirements.
➢ Any cycle can be deleted, if so desired.
➢ Any cycle enables the use of up to 3 thermal probes to control the temperature inside the
product.
➢ During the cooling/freezing cycle, the defrosting function is disabled, the fans are always
running. The defrosting cycle can be started before any cooling/freezing cycle.
➢ The cycle is divided into 3 phases that can be fully configured by the user.
➢ Each device allows for connection of the XR REP remote display to display the
temperature in the chamber or product.
9. ELECTRICAL CONNECTIONS
The devices are accompanied with the terminal unit used for the connection of cables with
the cross-section of up to 2.5 mm² for thermal probes and a digital input.
Use the power cord with heat-resistant braiding Ø 6.3 mm. Before connecting, make sure
that power supply conforms the device requirements. Input cables shall be laid separately
from the power cord.
9.1. Connection of temperature sensors
Temperature sensors are to be connected in such a way as to avoid accidental moisture in
connecting cartridges. To ensure more accurate measurements of the average temperature
in the chamber, it is recommended to place the temperature sensor outside the airflow.
During the defrosting cycle the defrosting sensor shall be placed between the evaporator
48