Apex XT Manual De Instrucciones página 9

Italiano
3 Installazione
3.1 Impostazione
1.
2.
3.
4.
Collocare il dispositivo CPAP sulla piattaforma del
riscaldatore. Posizionare il dispositivo CPAP in modo
tale che i quattro piedini corrispondano alle quattro
fessure della piattaforma e la linguetta di gomma sul
retro quest'ultima scorra nella scanalatura che si trova
nella parte posteriore dell'unità CPAP (dietro la presa
elettrica) a bloccare saldamente il dispositivo in
posizione.
Collocare il CPAP e la piattaforma del riscaldatore su
una superficie piana, a un livello più basso della
propria posizione da sdraiato.
Connettere il cavo elettrico alla presa CA sul retro del
dispositivo CPAP.
Collegare una estremità del cavo elettrico alla presa
sul retro del riscaldatore (ingresso) e l'altra alla presa a
muro.
NOTA: 1. Accertarsi che l'umidificatore riscaldato
sia adatto alla tensione elettrica locale.
2. La spina serve anche come dispositivo
di scollegamento.
94
English
6.
7.
The Heated Humidifier and CPAP device is now ready for use. Consult the CPAP user's
manual for the CPAP operating instructions.
Danger: In order to avoid damages to the CPAP equipment and prevent hazards from
electric shock, DO NOT pour water into the outlet port of the water chamber while
the water chamber is installed onto the humidifier. Also remember not to exceed
the high water mark (Fill Line) with water when filling the chamber with water.
5. Cleaning
5.1 Cleaning the Heater
1. Clean the humidifier by wiping it down with a damp cloth. Allow the heater to air dry
before connecting the power cords.
2. Inspect the humidifier and power cord for any damage and replace them if necessary.
5.2 Cleaning the Water Chamber
1. Turn the humidifier off and allow the heater plate and water to cool.
2. Disconnect the flexible tubing from the water chamber. Press down on the water chamber
and slide it off of the heater plate. Empty the remaining water.
3. Use the extraction tool to disengage the chamber base. The extraction tool
will be tucked into a recessed indentation on top of the humidifier platform.
Match the notch on the front right corner of the Plastic Chamber with the
inverted notch on the extraction tool so that the side of the tool is flush against
the side of the chamber base. Lever the extraction tool to pry the base gently
from the chamber.
4. Use a mild detergent to wash the chamber and base. Rinse all the parts with clean water and
allow each part to air dry individually.
5. All items of the chamber are subject to normal wear and tear and may eventually need
replacement. Replace the chamber parts if any damage is present.
Connect the other end of the flexible tubing to your
mask.
Adjust the heater temperature to the desired setting
by using the control knob.
1 is minimum humidity, 6 is maximum humidity. The
optimum setting is dependent on the ambient
temperature and humidity of your room.
7