Volume Adjustment; Using Intercom - Vertix Raptor-i Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Reject Call
EN
When a call comes in, the speaker will emit the mobile phone's ring. To reject the call, press and hold the call control button for about 2 secs,
release when you hear a low pitched "TOO" sound.
End Call
To end a call, simply press and release the call control button.
Transfering Call between your Raptor and mobile phone
While you are on the call, press and hold the CALL CONTROL button for 2 secs. Your call will be transferred to your mobile phone. To transfer
back to your Raptor, simply do the same, ie hold the CALL CONTROL button for 2 secs.
Voice Call
Some mobile phones have Voice Control functions. To activate the Voice Control, press the "VOL UP" button twice quickly.

Volume Adjustment

To adjust the volume, press and hold the VOL UP or VOL DOWN buttons until the desired volume is reached.
NOTE: When Maximum volume is reached, you will hear 2 low pitched beeps.

USING INTERCOM

Any paired Raptor-i unit can activate the Intercom function of the other paired Raptor-i units based on the command given and the current
function priority of the other paired Raptor units. The Intercom has "Middle" Priority. (See "MODE PRIORITY")
Enable Intercom (Last communicated or Paired Raptor-i)
To enable intercom function with the last communicated or Paired Raptor-i, press and release the POWER/INT button once.
To enable intercom function with the 2nd last communicated/Paired Raptor-i, press and release the POWER/INT button twice.
If the Raptor-i unit is in range and the connection is successful, you will hear a short "TOOT" sound followed by 3 ascending (low to high) tones if
YOU ARE INITIATING the call.
For receiving of intercom calls, you will just hear the 3 ascending tones.
If the connection was unsuccessful, the speakers will produce a long low pitched beep.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido