Important Notice; Conformity Notice; Fcc Notice - Vertix Raptor-i Manual De Instrucciones

IMPORTANT NOTICE

EN
Please comply with your local traffic laws when using this product and where required, you can detach one speaker. Safety must
always be your top priority. You are advised not to use this product under conditions which may put yourself or others at risk of
injury. Pull over to the road shoulder or a safe location to communicate when required. Adjust the volume prior to riding for each
available mode to your desired level bearing in mind that long exposure to loud sounds can cause hearing impairments. Users are
advised to test and acquaint themselves with the Raptor's Automatic Volume Control feature (only for mobile phone calls) which
automatically increases the volume when wind-noise is detected. The use of earplugs is highly recommended for riding speeds
in excess of 100kph (62mph) as wind-noise at high speeds is deafening. By opening and using this product, you explicitly accept the terms and
conditions for its use and should this product be given or loaned to another user, it is your responsibility to inform the user of the above terms and
conditions of use which shall also be applicable to him/her.

CONFORMITY NOTICE

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B Digital Device pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.
EUROPEAN CE NOTICE
This device is in conformity with the following directives:
EU Low Voltage, Directive 2006/95/EC; EU Electromagnetic Compatibility, Directive 2004/108/EC; R&TTE, Directive 1999/5/EC
2