Turning Off; Bluetooth ® Pairing - Vertix Raptor-i Manual De Instrucciones

Turning On
EN
Press and hold the ON-OFF/INT button. Release the button when you see the Blue light starting to flash or when you hear 6 ascending (low to
high) tones to signal that the set is now in service. If you have a paired mobile phone, you will also hear 2 high-pitched tones if it is connected.

Turning Off

Press and hold the ON-OFF/INT button until you hear a "DU DU" signal followed by 3 descending (high to low) tones.
®
BLUETOOTH Pairing
The Raptor-i is compatible with Bluetooth
Pairing Mode
Make sure your Raptor-i is OFF.
Press and do not release the ON-OFF/INT button until you see both Blue and Red lights flashing alternately.
You should hear a "DU DU". Your Raptor-i is now in Pairing Mode.
Note that the unit will automatically exit the Pairing Mode in about 60 seconds if pairing is not completed or unsuccessful. Repeat again if this
happens.
Mobile Phone Pairing
With the Raptor-i in Pairing Mode, turn ON your mobile phone's Bluetooth
manual if necessary.
Your mobile phone should detect "VTX-RAPTOR i_vx.xx.x."
Select this and enter the code 0000 (zero zero zero zero).
Note: To use the Raptor-i with a mobile phone and GPS Sat-Nav device at the same time, you will need to utilize the GPS Sat-Nav unit's phone
function. Please refer to your GPS Sat-Nav user manual for more information.
8
®
technology used for pairing mobile phones, music players and between Raptor-i headsets.
®
and search for devices. Please refer to your mobile phone's user