Cutting Line Replacement; Storing The Trimmer - Cramer 2100086 Manual De Instrucciones

Maintenance
Before each use, inspect the entire product for damaged, missing, or loose parts
such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged parts are replaced.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING!
Do not at any time let brake fluids, gasoline, petroleum based
products, penetrating oils, etc. come in contact with plastic parts.
They contain chemicals that can damage, weaken or destroy
plastic.
WARNING!
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Only the parts shown on the parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at an Authorised Service Centre.
Spool replacement (see Figure 8-9)
Use original manufacturer's replacement cutting line for best performance.
•
Remove the battery pack.
• Push in tabs on both sides of the spool cover.
•
Remove the spool cover and the old spool
• To install the new spool, make sure the cutting line is captured in the
slot on the new spool. Make sure the end of the cutting line is extended
approximately 15cm beyond the slot.
• Install the new spool so that the cutting line and the slot are aligned with
the eyelets in the cutting head. Thread the cutting line through the eyelets.
•
Pull the cutting line extending from the cutting head so the cutting line
releases from the slot in the spool.
•
Reinstall the spool cover by depressing tabs into slots and pushing down
until spool cover clicks into place.

Cutting line replacement

A (see Figure 10)
• Remove the battery pack.
•
Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the spool.
•
Cut a piece of cutting line approximately 3m long.
•
Bend the line at the midpoint and hook the loop into the slot in the center
rim of the spool. Ensure the line snaps into position in the slot.
•
Wind the line in the direction of the arrow shown on the bottom of the
spool. Once completed, put the line in the slots so it does not unwind.
• Do not wind the line beyond the edge of the spool.
B (see Figure 11)

Storing the trimmer

• Keep the air vents free of obstructions.
•
Remove the battery pack from the trimmer before storing.
• Clean all foreign material from the trimmer.
• Store it in a place that is inaccessible to children.
•
Keep away from corrosive agents such as garden chemicals and de-icing
salts.
•
Store and charge your batteries in a cool area. Temperatures above or below
normal room temperature will shorten battery pack life.
• Never store batteries in a discharged condition. Wait for battery pack to cool
and fully charge immediately.
•
Store the battery pack where the temperature is below 23˚C and away from
moisture.
•
All batteries gradually lose their charge. The higher the temperature, the
quicker they lose their charge. If you store your unit for long periods of time
without using it, recharge the batteries every month or two. This practice
will prolong battery pack life.
EN GB
9
cramer.eu