POSSIBLE PROBLEM
The 'preheat' alert sounds
at a lower temperature
than what is displayed
on the LCD screen
The LCD screen
displays 'E01'
The LCD screen
displays 'E02'
The LCD screen
displays 'E03'
The LCD screen
displays 'E06'
The LCD screen
displays 'E10'
The LCD screen
displays 'E11'
The temperature changes
when the convection
button is pressed
Noise from control panel
32
EASY SOLUTION
•
The 'preheat' alert sounds at 75% of the target temperature. This
provides the fastest, combined preheating and cooking time.
•
This is because when the 'preheating' alert sounds, signaling the user to
open the oven door and insert food, there is dramatic temperature loss
inside the oven. If the alert sounded at 100% of the target temperature,
opening the door would mean a lot of this waiting time is "wasted".
We have calculated that by sounding the alert at 75% of the target
temperature, followed by the oven door being opened to place food
inside the oven, that we still recover to the target temperature up to
2 minutes faster. Therefore, the temperature on the LCD screen does
not match the target temperature at the 'preheat' alert. Depending on
the set temperature, it can take the oven approximately 8–10 minutes
from start-up, including opening the oven door when the 'preheat' alert
sounds, to reach the target temperature.
•
The LCD screen will display 'E01' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the power outlet and contact Breville Consumer Support.
•
The LCD screen will display 'E02' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the power outlet and contact Breville Consumer Support.
•
The LCD screen will display 'E03' if the oven temperature is above the
set maximum limit. Remove the plug from the power outlet, allow the
oven to cool for 15 minutes, then plug back in.
•
Contact Breville Consumer Support if the 'E03' message continues.
•
The LCD screen will display 'E06' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the power outlet and contact Breville Consumer Support.
•
The LCD screen will display 'E10' if there is a problem communicating
with the Wi-Fi module. Remove the plug from the power outlet for 30
seconds, then plug back in.
•
Contact Breville Consumer Support if the 'E10' message continues.
•
The LCD screen will display 'E11' if the oven had encountered an issue
in the App. Please check the App for more information and details.
•
This is normal. The temperature is calibrated to compensate for the
convection fan increasing cooking rates.
•
During cooking, a cooling fan turns on to protect sensitive electronic
components from overheating. This fan can sometimes remain on for a
few minutes after cooking has finished.