Brinkmann 810-6680-S Manual Del Propietário página 13

MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Turn the burner control knobs to "OFF" .
3. Place a paper match in the end of the matchlighter. Strike the match and place
through lighting hole in the left hand side of the grill to approximately 1/2" (1 to
2 cm) from the burner.
4. Turn on the FAR LEFT burner control knob to the "HIGH" position.
The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes
to allow gas to dissipate and repeat lighting procedure.
6. To light other burners, push and turn control knobs to "HIGH" in sequence
from left to right.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem
is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
LIGHTING THE FRYER BURNER:
1. Open lid before lighting fryer burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn fryer burner control knob to the "HIGH" position.
4. Press the electronic igniter on the main control panel and hold
for 3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF" ,
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting"
section of the owners manual.
MATCH LIGHTING THE FRYER BURNER:
1. Open lid before lighting fryer burner.
2. Make sure control knob is in the "OFF" position.
3. Strike the match and place it approximately 1/2" (1 to 2 cm) from the burner.
4. Push and turn the fryer burner control knob to the "HIGH" position. The burner should light within
5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate
and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the fryer burner until the
problem is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
Note: Observe fl ame height when lit: Flame should be a Blue/Yellow color between 1"–2" when burner
is on "HIGH" .
See section in manual on burner adjustment to adjust fl ame.
Lighting Hole
Matchlighter
12