Operation And Functions; Fm Radio - auna Wallie 10033227 Manual De Instrucciones

EN
38

OPERATION AND FUNCTIONS

FM RADIO

1. Tap the STANDBY button (2) on main unit or (1) on remote control to
turn on the unit.
2. Tap the FUNCTION button (4) on main unit or the MODE button (7) on
remote control to select FM mode. The FM radio frequency will appear
on the display.
3. To manually tune to a specific radio station, tap the

BACK buttons on either main unit or remote control repeatedly. Use
the manual tuning method to tune in weaker stations that are bypassed
during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold

the FORWARD or
for 1-2 seconds until the frequency readout on the display begins to
scan and then release the button. The tuner will stop scanning when it
receives the next broadcasting station of adequate signal strength.
5. Press the VOLUME (+/-) buttons (17/18) on main unit or (4/11) on remote
control to adjust the volume control to the desired volume level.
FM & FM-Stereo reception
• When listening to the FM radio, press the ST./MONO button on the
remote control to switch between stereo mode and mono mode.
• The FM stereo icon "ST" will appear on the display if the unit is in stereo
mode.
• It is preferable to receive the program in mono when you are receiving
a weak station
Tips for best reception:
• The receiver has a build-in FM wire antenna hanging from the back of
the cabinet. This wire should be totally unwrapped and fully extended
for the best reception.
NOTE: Automatic tuning depends on the signal strength of the broadcasting
station, so weak stations may be skipped. You can manually tune to find the
weak stations if a station gets skipped. With strong signals, the tuner may
stop before it reaches the actual broadcast frequency, so you may need to
manually tune for the best reception.

BACK buttons on main unit or remote control

FORWARD or