Connection Assignment, Circuit Board Rocon Bm1; Mains Connection Daikin Altherma Ehs(X/H) - Daikin Altherma EHS Serie Manual De Instrucciones E Instalación

4 x Set-up and installation

4.5.5 Connection assignment, circuit board RoCon BM1

Fig. 4-20 Circuit board RoCon BM1 (masic control module)

4.5.6 Mains connection Daikin Altherma EHS(X/H)

A flexible cable for the mains connection is already connected in-
ternal to the device.
Check the supply voltage (~230 V, 50 Hz).
Disconnect the junction box of the domestic installation.
Connect the cable for the mains connection on the Daikin
Altherma EHS(X/H) to the junction box of the domestic instal-
lation via an all-pole disconnecting main switch to be installed
by the customer (separate isolator according to EN 60335-1).
Ensure that the polarity is correct.
The external device and optional accessories must be connected
separately to the regulator on the Daikin Altherma EHS(X/H).
To do so, the cover panel of the Daikin Altherma EHS(X/H) must
be removed (see section 4.3) and if necessary, the control
housing opened (see section 4.5.7).
Installation and operating instructions
28
Mains supply 230 V, 50 Hz
(Connection plan in this instruction manual)
Daikin Altherma EHS(X/H)
Daikin Altherma integrated solar unit
008.1441399_02 – 01/2021 – EN