Legend; Description Of The Machine; Technical Data; Installation And Setting Up - Proxxon PD 230/E Manual Del Usuario

Legend

1. Main spindle
2. Lathe chuck
3. Turning tool holder
4. Rotating centre
5. Flange surface for milling unit
6. Sleeve
7. Clamp screw for sleeve
8. Tailstock
9. Sleeve adjusting handwheel
10. Handwheel for leadscrew
11. Clamp screw for tailstock
12. Leadscrew
13. Adjusting handwheel for top slide
14. Top slide
15. Support
16. Cross-slide
17. Adjusting handwheel for cross-slide
18. Clutch switch for automatic feed
19. Drive gearbox cover with speed table
20. Switch for anticlockwise rotation - stop - clockwise
rotation
21. Main switch
22. Function display
23. Control
24 Hollow hexagon wrench
25. Lathe chuck wrench
26. Chuck guard

Description of the machine

The PROXXON lathe PD 230/E is an extensible system which
consists of
• solid shaft electronics for high torques over the entire
speed range
• automatic feed
• lathe chuck and
• rotating centre
for machining steel, brass, aluminium and plastics.
It can also be used for face turning, longitudinal turning and
thread cutting.
The machine is also suitable for boring, milling work and
grooving by using the appropriate accessories.
The ribbed, grey cast iron machine bed with ground prismatic
guideways ensures vibration-free work.

Technical data

Centre distance
Centre height
Height above support
Holding capacity
- Inner jaws
– Outer jaws
Cross-slide adjustment
Top slide adjustment
Spindle passage
Nose support on chuck side
Tool holder
Machine dimensions
Weight
Possible thread leads
Spindle speeds
– by shifting the V-belt
– by control
Feed
Sleeve motion
Sleeve for morse taper
Motor
Voltage:
Power consumption
Noise emission
Please do not dispose off the machine!

Installation and setting up

The standard equipment of the PROXXON Lathe PD 230/E
consists of the following parts:
• Metal working lathe complete with motor, automatic feed
and triple jaw chuck including chuck key and chuck guard
and accessories.
• rotating centre
• tool kit
• change gear kit for thread turning
• tool holder,
• Removable toothed belts.
The floor space must be even, vibration-free and stable. The
machine must be fastened to a stable work bench using the
bores provided.
230 mm
52 mm
28 mm
2 - 35 mm
24 - 68 mm
60 mm
45 mm
10.5 mm
MK1/short
8x8 mm
530x260x150 mm
approx. 10 kg
0.5/0.625/0.7/0.75
0.8/1.0/1.25 and 1.5 mm
400/1600/ and 3000 rpm
25% to 100%
0.05 and 0.1 mm/revolution
30 mm
MK 1/short
220-240 Volt, 50 Hz,~
140 Watt
≤70 dB (A)
- 17 -