CST/BERGER XP5 Manual De Instrucciones página 4

Thank you for purchasing our XP5 Self-Leveling Laser.
Please read this manual thoroughly before operation.
EN
Copyright © 2008 CST/BERGER, All rights reserved.
The information contained herein is proprietary information of CST/BERGER and is
subject tochange without notice.
This document shall not be copied or otherwise reproduced without CST/BERGER's
written consent.
SAFE OPERATING PROCEDURES
WARNING: Be sure to read and understand all instructions in this manual before using
this product. Failure to follow all instructions may result in hazardous radiation exposure,
electric shock, fire, and/or bodily injury.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified in this manual, may result in hazardous radiation exposure.
CAUTION: The use of optical instruments with this product will increase eye hazard.
IMPORTANT: The following labels are on your laser tool for your convenience and safety.
They indicate where the laser light is emitted by the level. ALWAYS BE AWARE of their location
when using the level..
ACCORDING TO IEC/EN 60825-1: 2007
ALWAYS make sure that any bystanders in the vicinity of use are made aware of the dangers of
looking directly into the laser tool.
DO NOT remove or deface any warning or caution labels. Removing labels increases the risk of
exposure to laser radiation.
DO NOT stare directly at the laser beam or project the laser beam directly into the eyes of others.
Serious eye injury could result.
DO NOT place the laser tool in a position that may cause anyone to stare into the laser beam inten-
tionally or unintentionally. Serious eye injury could result.
DO NOT use any optical tools such as, but not limited to, telescopes or transits to view the laser
beam. Serious eye injury could result.
ALWAYS remove the batteries when cleaning the laser light aperture or laser lens.
DO NOT operate the laser tool around children or allow children to operate the laser tool. Serious
eye injury could result.
4 • XP5
ACCORDING TO IEC/EN 60825-1: 2007