JUKI M92 Instrucciones Suplementarias Para La Instalacion Y El Uso página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
6. Adjusting the belt cover (when M92 is used)
4mm
(1) Adjusting the clearance of the cover
(Caution) When adjusting the belt cover, take
(2) Installing the belt cover
(3) Adjusting the roll-in prevention pin
(Caution)
(4) Adjusting the prevent dropping plate
Motor pulley
(Caution) When adjusting the belt cover, take care
3mm
– 4 –
Loosen two belt cover setscrew ❸ and adjust so
that the right and left clearances between the belt
cover ❶ and belt ❷ are equal.
care not to loosen the setscrew excessively.
Aligning the convex sections on outer side ❹ of
the pulley cover with tapped holes ❺ (two loca-
tions) inside the pulley cover, tighten the screws.
Adjust entanglement preventing pin ❻ with the
screw ❼ supplied with the unit so that a clear-
ance of approximately 4 mm is provided between
the belt ❷ and the pin.
1. Be careful of the direction of rotation of the
motor and determine the position of the pin
❻ . (Position shown in the figure is the in-
stalling position when the motor rotates in
the direction of the arrow mark.)
2. When adjusting the belt cover, take care not
to loosen the setscrew excessively.
Loosen screw ❽ . Adjust so that a clearance of
approximately 3 mm is provided between belt ❷
and prevent dropping plate ❾ .
not to loosen the setscrew excessively.

Publicidad

Tabla de contenido
loading

Tabla de contenido