Allmand NIGHT-LITE V Serie Manual Del Usuario página 14

WARNING
Failure to use new, correctly tightened nylock nuts to attach
the hitch bar to the trailer tongue could result in death or
serious injury. Always use new, properly tightened nylock
nuts when attaching the hitch bar to the trailer tongue.
7
Trailer Coupler
To connect the trailer to the tow vehicle
1. Lift up and pull back on the locking latch (A, Figure 8) of
the trailer coupler.
2. Lower the trailer coupler onto the vehicle ball hitch. Make
sure that the hitch ball (B, Figure 8) is fully engaged in the
coupler socket (C).
3. Push the locking latch forward and down. (It is self-
locking.) Install a padlock through the latch hole (D,
Figure 8) for added security.
4. Make sure that the coupler is fully installed on the ball
hitch.
To disconnect the trailer from the tow vehicle
1. Remove the padlock (if installed) from the trailer coupler
latch (D, Figure 8).
2. Lift the trailer coupler (A, Figure 8) latch up and back.
14
8
Lunette Eye
To connect the trailer to the tow vehicle
1. Remove the locking pin (A, Figure 9, if equipped) from the
pintle hitch (C).
2. Pull up on the latch (B, Figure 9), to open the pintle hitch.
3. Lower the lunette eye (D, Figure 9) into the pintle hook
(E).
4. Close the pintle hitch. Make sure that the latch locks the
pintle hitch in place.
5. Install the locking pin (if equipped).
To disconnect the trailer from the tow vehicle
1. Remove the locking pin (if equipped) from the pintle
hitch.
2. Pull up on the latch to open the pintle hitch.
3. Remove the lunette eye from the pintle hook.
9
www.allmand.com