Allmand NIGHT-LITE V Serie Manual Del Usuario página 15

Light Tower Trailer Weight
WARNING
Towing the light tower trailer when it is loaded beyond the
Gross Vehicle Weight Rating (GVWR) could result in death
or serious injury. Always maintain a gross vehicle weight
less than the GVWR stated on the serial plate and in the
Specifications section of this manual.
The light tower trailer is an SAE Class 2 trailer, with a Gross
Vehicle Weight Rating (GVWR) as stated on the serial plate
and in the Specifications section of this manual. Do not
exceed the GVWR by attempting to carry additional tools or
equipment. Do not carry riders. See Safety .
Towing the Light Tower Trailer
WARNING
Excessive speed when towing the trailer could result in
death or serious injury. Always maintain a safe towing
speed for road conditions. Never exceed 65 MPH (105 km/
h) when towing the trailer.
WARNING
Rollover Hazard
Do not make sharp turns at high speeds when towing the
light tower trailer. This could cause the light tower trailer
to roll over, resulting in death, serious injury, or equipment
damage.
The rated maximum highway towing speed for the light tower
trailer is 65 MPH (105 km/h). Be sure to check your state or
province laws regarding maximum legal towing speeds for
trailers.
When towing the trailer off-highway or on rougher terrain, the
maximum towing speed is 20 MPH (32 km/h). Slower speeds
may be required for very rough terrain.
Tow the light tower trailer with the engine and lights shut
down.
Do not carry riders.
Disconnecting the Light Tower Trailer from the
Tow Vehicle
1. Select a firm, level and stable surface at the work site.
See Work Site Considerations in the Operation
section.
2. Position the light tower trailer as desired with the tow
vehicle.
3. Chock the wheels on both sides of the trailer.
WARNING
Crush Hazard
Attempting to move or position the light tower trailer by
manually pushing or pulling it could present a crush hazard
resulting in death or serious injury. Always position the
trailer with the tow vehicle, chock the wheels, and lower
the tongue jack before uncoupling the trailer from the tow
vehicle.
4. Disconnect the trailer lighting connector from the tow
vehicle lighting connector.
5. Rotate the tongue jack into the operating position. See
Operating the Tongue Jack .
6. Lower the tongue jack foot to support the front of the light
tower trailer. See Operating the Tongue Jack .
7. Uncouple the trailer coupler from the tow vehicle. See
Using the Trailer Coupler / Lunette Eye .
8. Use the tongue jack to raise the trailer coupler or lunette
eye above the tow vehicle's hitch ball or pintle ring.
9. Disconnect the safety chains from the tow vehicle's hitch
frame.
10. Move the tow vehicle clear of the light tower trailer.
11. If desired, pivot the trailer tongue up to the park position.
See Trailer Tongue .
Transporting on a Trailer
The unit is equipped with four (4) tie-down points. See
Features and Controls for tie-down point locations.
Always secure the light tower trailer with appropriate chains
or straps. Do not apply more than 600 pounds (272 kg) force
on the chains or straps.
The truck operator is responsible for securing the load
properly to his transporting trailer.
Note: When transporting on a trailer, position the two top
light fixtures straight down to provide additional overhead
clearance. See Figure 10.
10
15