Troubleshooting; Troubleshooting Chart; Addendum - Unit Options - Allmand NIGHT-LITE V Serie Manual Del Usuario

Engine - Perkins
Service Interval - Oil Change 1000 hrs
& Filter

Troubleshooting

Before performing any troubleshooting procedures,
read Safety as well as the following safety messages.
For engine and generator troubleshooting, refer to the Engine
Operator's Manual and Generator Operator's Manual, or
contact your dealer.
WARNING
Electrocution Hazard
• Ballast and capacitors are capable of discharging high
voltage.
• High voltage is present when engine is running. Never
attempt to service electrical components while engine is
running.
• Contact with wires made bare by damaged, cut or
worn insulation could result in death or serious injury.
Replace damaged wiring before operating unit.
WARNING
Burn Hazard
• The light fixtures become extremely hot during use.
• Always use caution and heat–resistant glove when
handling the lights or allow the lights to sufficiency cool
down before handling.
Always follow the electrical component manufacturer
specifications for voltage and test procedures.
Troubleshooting Chart
Problem Possible Cause
Light(s) not Breaker(s) in outlet box not
operating turned on or tripped.
Lights not allowed ample time
to cool after operation.
Connection between light bar
and fixture(s) not secure.
Lamp(s) not screwed in
securely.
Lamp(s) burned out or
broken.
Wrong style replacement
lamp(s) installed.
Too much power being drawn
from auxiliary outlets.
Temperature of ballast below
-29°C (-20°F).
Ballast capacitor or
transformer has failed.
32
Remedy
Turn on / reset breakers.
Allow 15 minutes between
shutting down and restarting
lights.
Check and secure
connections.
Tighten lamp(s).
Replace lamp(s).
Install correct replacement
lamp(s).
Remove load(s) from auxiliary
outlets.
For operations where
temperature of ballast falls
below -29°C (-20°F), some
means of warming ballast must
be used.
Replace ballast capacitor or
transformer.
For all other issues, contact your authorized dealer.

Addendum - Unit Options

Battery Disconnect
The optional battery disconnect allows convenient, tool-free
disconnection of the battery while the unit is in storage or not
in use, or to prevent unauthorized unit operation.
To disconnect the battery:
1. Turn the switch (A, Figure 36) to the Disconnect position
(B).
2. A padlock (not supplied) can be used for added security.
To connect the battery:
1. Remove the padlock (if used).
2. Turn the switch to the Connect position (C, 36).
36
www.allmand.com