Monosem CS 7000 Manual Del Usaurio página 85

216 LOW PRESSURE
The identified pressure sensor has detected a pressure that exceeds the threshold for the Low Pressure Alarm
value.
217 MODULE CONFIGURATION ERROR DURING SENSOR DETECT
218 PRESSURE CONFIGURATION ERROR DURING SENSOR DETECT
219 ROW CONFIGURATION ERROR DURING CELL DETECT
220 ROW INSTALLATION CONFIGURATION DURING CELL DETECT
221 INVALID CONTROL STATE
222 CONTROL STEP HEIGHT FAILURE
223 CONTROL MAX FEEDBACK
224 CONTROL NO GAIN STEPS FAILURE
225 HOPPER LOW
The identified hopper sensor has detected a low level condition.
226 RPM HIGH LIMIT EXCEEDED
The identified RPM sensor has detected a pressure that exceeds the threshold for the High RPM Alarm value.
227 RPM LOW LIMIT EXCEEDED
The identified RPM sensor has detected a speed under the threshold for the Low RPM Alarm value.
228 HOPPER CONFIGURATION ERROR DURING SENSOR DETECT
An incorrect number of hopper sensors have been detected other than the one configured in the Configuration of
the Module. Verify that the correct number of hopper sensors is entered for each module.
229 HOPPER INSTALLATION ERROR DURING SENSOR DETECT
230 PRESSURE INSTALLATION ERROR DURING SENSOR DETECT
An incorrect number of pressure sensors have been detected than are configured for in the Module
Configuration. Verify that the correct number of pressure sensors is entered for each module.
231 SEEDING ON A TRAMLINED ROW ALARM
A row that has been configured for a tramline output is still seeding when the tramlined output is active. This
could indicate failure with the tramline clutch, or the output has been installed on an incorrect row.
232 RPM LOW LIMIT CONTROL SHUTDOWN
602 EIGHT VOLT FAILURE
The +8VDC power output from the identified module has failed. Usually caused by a short in the module
harness, but can also indicate a failed module. Check for harness damage.
603 COMMUNICATION OF A DEFECTIVE SECONDARY MODULE
A secondary module has failed to communicate. This could be caused by a damaged harness, or a failure of the
identified module.
604 ECU VOLTAGE FAILURE
605 SOLENOID POWER FAILURE
606 GROUND OFFSET FAILURE
- 83 -