Stellcase Workplace Advisor Instrucciones De Instalación página 3

®
ACTIVATE
1. Open package for space and verify you have the correct number of sensors/mounting brackets by referencing the installation plan.
2. Activate sensors by opening the sensor and pulling out the battery tab as shown below (Note: This must be done in the room the sensor is assigned to;
activating the sensor in any other location may cause the sensor to not communicate properly when installed.)
- Push/slide lock at end of sensor to unlock position
Locked
- Immediately after battery is activated, turn the sensor over to see the LED flashing pattern.
After the LED blinks (RED-YELLOW-GREEN) the sensor will be activated.
Once the sensor is activated:
• The LED will begin to blink RED continuously until paired.
• If pairing was successful, the LED will blink (GREEN-GREEN-GREEN).
• Once the sensor is paired, the LED will NOT blink again.
- Slide rear housing back in place and lock shut. Sensor will not fit in the mounting bracket unless the housing is locked.
- Confirm sensor online status by looking at Device Manager in Workplace Advisor. If sensor is not online, begin troubleshooting.
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS THAT
COME PACKAGED WITH REPLACEMENT BATTERIES.
Unlocked
LED
WARNING
- Slide off rear housing (1) and pull battery tab (2)
NOTICE
DO NOT unbox sensors until on
site and in the assigned space.
Sensors are pre-packaged per
space and pre-assigned to
spaces in Workplace Advisor.
Page 3 of 41
1083528001 Rev B