Stellcase Workplace Advisor Instrucciones De Instalación página 9

®
PLACE | Ceiling Sensor
Ceiling sensors
- Determine placement of ceiling sensor:
 If mounting to the acoustic ceiling tiles, use the spring staple from optional hardware package
WITH the adhesive tape. See page 11.
 Be sure to allow at least 2" from the end of the sensor to any obstacle to allow clearance to remove
the sensor from the mounting bracket.
- Remove backing from adhesive strip
- Attach sensor/mounting bracket to surface
- Apply force to mounting bracket for at least 15 seconds to ensure bonding to surface. Full bonding time is 72 hours.
- Align the tab on the sensor to the corresponding slot on the mounting bracket ()and insert sensor into
the bracket until it locks in place.
Side view
(shown with spring staple
for acoustic tile)
{acoustic tile}
Distance to wall ±3" (75mm)
IF THE ACOUSTIC TILE STAPLE WILL
NOT WORK use the anchors/screws
available in the optional hardware
package (ordered separately, style
#ST02MKSC20)
Distance to wall ±3" (75mm)
NOTICE
Page 9 of 41
1083528001 Rev B