Stellcase Workplace Advisor Instrucciones De Instalación página 8

®
PLACE | Corner Sensor
Corner sensors with pre-installed adhesive tape (for screws from optional hardware package, refer to page 12)
- Determine placement of wall sensor:
Place corner sensor on the wall 10' (3.05m) above the floor or as close to the ceiling as possible.

Maximum placement height is 12' (3.65m).
It's best to dry fit the sensor to its proper location prior to permanently affixing the mount.

 Corner sensor should be placed at least 12" (300mm) from any opening to prevent it from looking outside the room.
 Be sure to allow at least 2" from the end of the sensor the ceiling to allow clearance to remove the sensor
from the mounting bracket.
- Remove backing from adhesive strips
- Bracket can be tricky to get into corner perfectly. The best method is to push top edge into corner first and
rotate the bracket downward into place.
- Apply force to mounting bracket for at least 15 seconds to ensure bonding to surface. Full bonding time is 72 hours.
- If corner is not square enough to bond to both walls at the same time, use mounting screws and attach to just one wall.
(Refer to page 12.)
- Align the tab on the sensor to the corresponding slot on the mounting bracket ()and insert sensor into
the bracket until it locks in place.
Distance to floor ±3" (75mm)
Top down view
NOTICE
Sensor(s) SHOULD NOT be able to sense
motion outside of the room; i.e., the "cone of
vision" should not fall outside of room/doorway.
Corner sensors should always be adhered at
10' high or ceiling height (whichever is lower)
Page 8 of 41
1083528001 Rev B