RECARO C 6000 Manual Del Usaurio página 49

3. Align the console with the screw holes on the floor of the vehicle.
4. Screw the five original screws (1, 2) previously removed into the floor of the vehicle and use appropriate
bolt adhesive (hand-tight only).
5. Screw the console onto the floor of the vehicle. (SW 14 adapter)
Torque: M10 screws: 45 Nm ± 2 Nm
Warning!
Ensure that you neither exceed nor fall short of the torque listed above.
If the torque is insufficient, the screws will work loose whilst you are driving. The thread might be
damaged if the torque is too high. The risk of an accident and being injured whilst driving exists in
both cases.
The vehicle must be stopped immediately if a screw works loose and the screws must be replaced
by new screws or with the bolt adhesive and tightened to the stipulated torque.
Y
6. Mount the vehicle electrical connection (2) on the bracket on the rear of the console and connect it with
the connector on the seat.
7. Connect the vehicle air connection with the connector on the console (1) (SW 16 spanner).
RECARO Automotive Seating
1 Air connection
2 Electrical connection
Page 22