Continuity Mesurement; Diode Test - koban KMD 06 Manual De Instrucciones

• For increased accuracy when measuring low resistances, short the test
leads, record the value displayed, then connect the leads to the circuit and
substract the shorted value from the circuit measurement.
• When the leads are disconnected from the circuit under test, OL will be
displayed on the screen.
Warning
To prevent injury or damage to the meter, turn off power to circuit and
discharge all capacitors fully before making resistance mesurements.

Continuity mesurement

• Turn off power power to the circuit. Allow all capacitors to discharge.
• Set the rotary switch to the continuity position.
• Connect the red test lead to the input jack and the black lead to the COM
jack.
• Connect the leads to the circuit under test. If the measured resistance is
less than 50Ω, the buzzer will sound.
Warning
To prevent injury or damage to the meter, turn off power to circuit and
discharge all capacitors fully before making continuity mesurements.

Diode test

• Turn off power power to the circuit. Allow all capacitors to discharge.
• Set the rotary switch to the diode position.
• Connect the red test lead to the input jack and the black lead to the COM
jack.
• Connect the red test lead to the anode (+) and the black lead to the
cathode (-) of the diode and red the measurement on the display. The
meter will display OL if the connection is reversed.
Warning
To prevent injury or damage to the meter, turn off power to circuit and
discharge all capacitors fully before making diode mesurements.
Battery test
• Set the rotary switch to the appropriate battery test range.
• Connect the red test lead to the input jack and the black lead to the COM
www.grupotemper.com
KMD 06
Digital multimeter
Instructions manual | 21