Maintenance - Sputnik Engineering SolarMax 2000S Documentación Del Dispositivo

El inversor para sistemas de electricidad solar conectados a la red
Ocultar thumbs Ver también para SolarMax 2000S:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Malfunction: Vac too low or Vac too high
Possible cause
Mains voltage too low / too high
Possible cause
The solar generator voltage exceeds
the permissible value
(see Technical data)
Possible cause
Internal temperature too high or
internal fan faulty
Possible cause
Internal temperature too high, or
external fan faulty
Alarm: Failure temp. sensor
Possible cause
Internal temperature too high or
temperature sensor faulty
Possible cause
Internal temperature too high: device
reduces output. Check function of the
external fan; check and clean the fan
grille.
89
Remedy
Check mains voltage
Malfunction: Vdc too high
Remedy
Immediately disconnect the DC
insulation switch
Check module confi guration
Alarm: Failure fan 1
Remedy
For recurring faults contact the Solar-
Max hotline
(A faulty fan leads to power reduction
or even total shutdown.)
Alarm: Failure fan 2
Remedy
For recurring faults contact the
SolarMax hotline
Remedy
For recurring faults contact the
SolarMax hotline
Alarm: Temp. limitation
Remedy
For recurring faults contact the
SolarMax hotline
Fault: Device error
Possible cause
Remedy
Internal fault
For recurring faults contact the
SolarMax hotline
The following error messages can be displayed only during SolarMax initialisation.
They indicate a device fault:
Error message
SUPPLY FAILURE
For recurring faults contact the
SolarMax hotline
ADC REFERENCE ERROR
EEPROM ERROR
CONFIGURATION ERROR
Wait until irradiance is high enough
IRRADIANCE TOO LOW

6.3 Maintenance

The SolarMax inverters generally operate maintenance-free. However, we recom-
mend checking the AC output in the LC display during strong irradiance at regular
intervals.
The cumulative operating and kilowatt hours provide additional information about
the performance of your PV system.
A faulty external fan can be replaced without having to open the device: simply
release the four fastening screws of the fan and open the cable plug.
Before changing the external fan disconnect the DC circuit breaker and the AC
side!
en
Remedy
90

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Solarmax 3000sSolarmax 4200sSolarmax 6000s

Tabla de contenido