Something Not Working; Troubleshooting - AEG Electrolux LAVAMAT L 60890 Instrucciones Para El Uso

132984631_gb.qxd 14/10/2005

Something not working?

detergent drawer and then run the drain programme "C". This will acti-
vate the ECO valve avoiding that part of the detergent remains unused
at next washing.
Something not working?
If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due
to the modern technology of new washing
machines that use less water than tradition-
al machines.

Troubleshooting

If a problem arises, you can try to solve it
yourself following the instructions below.
If you call out an engineer when one of the following problems aris-
es, or to repair a fault due to incorrect use, the call-out will be
charged even if requested within the guarantee period.
During machine operation it is possible that an acoustic warning signal
sounds, the FIN (END) light blinks and the following alarm codes may be
displayed:
- E10: problem with the water supply
- E20: problem with water draining
- E40: door open
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, con-
tact your local AEG/ELECTROLUX Service Force Centre.
The machine does not work
74
09:50 Pagina
Problem Possible cause
The main electrical fuse
has blown.
The door is not properly
closed (E40).
The plug is not connected. Insert the plug.
The START button has not
been pressed.
The DELAY START
option has been selected.
74
Replace the fuse.
Close the door; the click
of the lock should be heard.
Press the button.
Check the selected delay on
the display.
Solution