Operating Instructions; Pre-Start Checklist; Before Starting Engine; To Start Engine - American-Lincoln 4366XP Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS

PRE-START CHECKLIST

1.
Clean engine air fi lter element if needed
2.
Check engine oil level
3.
Check radiator coolant level
4.
Check hydraulic fl uid level
5.
Check fuel level
6.
Check all systems for leaks
7.
Check brakes and controls for proper operation

BEFORE STARTING ENGINE

1.
Set Parking Brake.
2.
Make sure all controls are in the "Off" position.

TO START ENGINE

1.
Be sure accelerator and directional control pedal is in neutral.
2.
Turn key to "On" position & release.
3.
If engine fails to start after following the above procedures, refer to Engine Manual.
When machine has been stored in below-freezing temperatures, run engine at not over 1/2 throttle with machine standing still for 5 to 10 minutes to
POST-START CHECKLIST (Engine Running)
1.
Check main and side brooms to make sure they are free of debris which will inhibit rotation & pick-up.
NOTE: Always wear hand protection when cleaning debris from brooms and/or brushes.
2.
Check squeegees to make sure there is no damage and they meet the fl oor.

TO OPERATE SWEEPER

1.
Make sure parking brake is released.
2.
Lower the side and main broom to the fl oor. (The main broom control may be placed in either the "FLOAT" or "SWEEP" position.)
3.
Turn Broom Fan Switch on.
4.
Pull engine throttle to "UP" position. (Engine must always be operated at full governed speed while sweeping to obtain recommended brush speed and dust
control).
5.
Push forward on directional control pedal to place machine in motion.
6.
Vary your foot pressure on the directional control pedal to obtain desired travel speed.
TO STOP SWEEPER
1.
Allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to neutral when foot pressure is released.) FOR
NORMAL OPERATION, DEPRESS DIRECTIONAL CONTROL PEDAL WITH HEEL INTO NEUTRAL.
2.
Depress the foot brake.
3.
Turn Broom Fan Switch off.
4.
Put the broom controls (Side and Main) in the "UP" position.
5.
Push engine throttle down. Turn key to "OFF."
6.
Set parking brake.
NOTE
Before starting the engine, perform these pre-start checks.
NOTE
warm engine and hydraulic oil.
ENGLISH / A-13
FORM NO. 56041727 - 4366XP - A-13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido