Towing Instructions; Dust Filters; Dust Control System - American-Lincoln 4366XP Instrucciones De Uso

A-16 / ENGLISH
OPERATING INSTRUCTIONS
View of drive pump from front of machine
FIGURE 12
The main broom and impellor fan will shut off automatically when the shaker motor is cycling.
A-16 - FORM NO. 56041727 - 4366XP

TOWING INSTRUCTIONS

1. Locate tow control shaft extension (A) as shown in Figure 12. The tow control shaft is
located underneath the pump.
2. To open hydraulic circuit to wheel drive motor turn shaft 90°.
3. After towing, turn shaft 90° to its original position.

DUST FILTERS

The Filter Panel can be periodically removed from the hopper and blown off with compressed air
(not to exceed 100 P.S.I.) or cleaned with soap and water. (Do not attempt to use Filter Panels
that have not dried completely.)
THE DUST CONTROL SYSTEM
The baffl e system that is built into the debris hopper is designed minimize dust in the air while
the machine is sweeping.
The debris from sweeping is thrown into the hopper. The impeller vacuum fan pulls the lighter
dust up and through a baffl e system. The Pre-Clean Flap separates the heavier dust particles
to an area below the fi lter. The lighter dust particles are captured by the dust fi lter. This allows
the dust fi lter to remain cleaner and need less shaking to remove dust. When the dust fi lter
becomes clogged the fi lter shaker switch should be pushed to start the dust shaker cycle. This
will extend the life of the fi lter.
NOTE
FIGURE 13