Sun Enterprise 220R Manual De Instalación Y Montaje página 24

6. Secure the chassis to the left and right vertical rails at the front of the rack.
Use a Phillips #2 screwdriver to tighten the four captive screws that secure the
system in the rack enclosure. These screws are in recessed access holes in the
decorative panels affixed to the system's front panel, as shown.
Note – If you removed the side panels from the rack enclosure, leave them off until
after you complete the procedures in Chapter 3.
What Next
Go to Chapter 3 and complete the procedures for connecting the power cord and
cables to the back panel, powering on the system, and installing the operating
system.
en-20 Sun Enterprise 220R Server Setup and Rackmounting Guide • December 1999