Motor Asset Of Line W60 - WEG Motor Scan Manual Del Usuario

2.4 POSITIONING OF THE SENSOR - APPLICATION: WEG ELECTRIC MOTOR ASSET
OF LINE W60
Due to the design of W60 motors, it is recommended to mount the WEG Motor Scan on the side base
(Figure 2.7 on page 10). The WEG Motor Scan must be positioned at the shaft center height, centered in the
motor length. If the terminal box occupies the indicated position, the WEG Motor Scan must be placed on the
opposite side of the terminal box. The sensor can be positioned with an offset of up to 40 mm in the axial direction,
and up to 20 mm in the transverse to the axial direction in relation to the recommended position.
Figure 2.7: Detail of the position for mounting the device of the WEG Motor Scan system on W60 motors
ATTENTION!
In order to install the WEG Motor Scan on assets not covered in this manual and motors from other
manufacturers, refer to WEG: www.weg.net/wegmotorscan.
Positioning of the Sensor for Installation
Installation Manual | 10