Procedure To Installation; Electric Motor Asset - WEG Motor Scan Manual Del Usuario

3 PROCEDURE TO INSTALLATION

3.1 PROCEDURE FOR INSTALLATION WITH BUSHING - APPLICATION: ELECTRIC
MOTOR ASSET
For the correct mounting of the sensor on the motor, follow the steps below:
1. With the motor turned off and following all the safety instructions in this manual, locate the motor fin where the
sensor must be fixed. According to the positioning guidelines indicated in
SENSOR FOR INSTALLATION on page
2. For motors with fins, drill a through hole in the fin. In motors without fins, make a 9 mm deep hole. To that end,
use a 5.9 mm (15/64") drill bit.
3. Using a hammer, insert the knurled bushing into the hole until the flange touches the motor fin. (Note: If the
sleeve is inserted without the aid of hammer means that the hole was slightly larger diameter, in which case
the sensor fixing the engine will be compromised. Therefore, it is necessary to make a new hole for the correct
fixing of the bushing).
4. Using a 3 mm Allen wrench, screw the sensor into the knurled bushing and check its tightness. Maximum
tightening torque of 2.8 Nm. According to
6, make the marking to drill.
Figure 3.1: Detail of insertion of the knurled bushing
Figure 3.2 on page
Figure 3.2: Sensor tightening detail on knurled bushing
Procedure to Installation
Chapter 2 POSITIONING OF THE
11.
Installation Manual | 11