Printing In Color - Rimage PrismPlus! Guia Del Usuario

Rimage PrismPlus!

Printing in color

1. Install a multicolor ribbon in the printer. Refer to Changing the print ribbon on page 18.
2. Navigate to printing properties.
3. Select the Device Settings tab.
4. Select the Installed Ribbon setting.
5. Select Color, Three Panel CMY from the drop-down list.
Note: The Double Print selection is disabled when a color ribbon is selected because
double print is not available during the color printing process.
6. Select the Media Type
7. Select the Print Strobe setting and set the value from
Media Surface
DVD or Regular
Thermal white overcoat
Note: This may require multiple test printings on discs to fine-tune the color hue. Set
Enable Color Sub-Strobes to Enabled to lower an individual color's print strobe. For
example, this setting can be used to lower the Yellow Print Strobe setting when trying to
eliminate a halo effect on a printed disc.
8. Select the Detect Media Change option:
•
If you are using a Rimage Producer system or an AutoPrinter, select No.
•
If you are making multipl
Note: When the Detect Media Change option is enabled, you must press the
operator button after you remove the printed disc and place a new disc on the
9. Disable Perfect Print option. This option is only used for the Rimage AutoPrinter.
10. To make changes that affect c
Halftone Setup Properties.
11. To save the changes, select OK.
14
.
e copies on a standalone printer, select
olor intensity, color balance, or pattern settings, select
.
the table below
Print strobe setting for
multicolor ribbon
375 - 425
375 - 425
Yes.
tray.
110635_H