Rimage PrismPlus! Guia Del Usuario página 26

Rimage PrismPlus!
d. Roll the ribbon leader so that it is
wrapped only once around the roller.
Important! Do not roll past the
marking on the leader that states
STOP - Wind Leader Onto Take-
up Core Stopping here.
e. Install the cardboard take-up roller in
the printer as shown. The ribbon
should be tight and there should be no
creases in the ribbon.
f. Install the take-up roller in the PrismPlus and press down firmly until the take-up roller
snaps into place.
Important! Do not roll the STOP - Wind Leader Onto Take-up Core Stopping here
marking on the ribbon leader onto the take-up roller. The marking should not be past the
point shown in the picture on page Error! Bookmark not defined.. If the marking is on
the roller, pull the take-up roller out and roll back the ribbon. To take up the slack, roll
the supply roller back.
4. To close the tray, press the operator button.
Note: During the ribbon validation process, the ribbon cycles past the ribbon leader. After
the ribbon validation process, ensure that the ribbo
5. Install the top cover. The PrismPlus is ready for use.
20
Ribbon Leader
Marking
n is tight.
Take-up Roller
110635_H