Replace Consumables; Changing The Print Ribbon - Rimage PrismPlus! Guia Del Usuario

Rimage PrismPlus!

Replace consumables

Changing the print ribbon

Tip: If ribbons are stored in an environment much different from that of the printer, allow time
for them to become acclimated to the new environment. Allow more time for greater
temperature and/or humidity differences.
Store the ribbons at -5°C (23°F) to 40°C (104°F) and at 30-80% relative humidity, non-
condensing. Avoid direct sunlight.
Note: If you are replacing the ribbon, now is a good time to clean the printhead. Refer to
Cleaning the printhead
1. Access the ribbon area.
a. Power on the PrismPlus.
b. Remove the top cover of the printer.
c. To remove the take-up roller, pull up
on it so the end with the gear comes up
first, and lift the take-up roller out of the
printer.
d. To remove the supply roller, lift it up.
2. Load the print ribbon
a. Slide the print ribbon onto the supply
roller.
b. Align the two notches of the cardboard
core to the metal pins on the supply
roller.
c. Peel the ribbon leader from the supply
ribbon.
d. Slide the ribbon leader under the
ribbon guide.
e. Tape the ribbon leader to the back of
the printer tray as shown.
18
on page 16.
.
Pull back
Take-up Roller
Print Ribbon
Cardboard
Core
Metal Pins
Supply
Roller
Tape
Printer Tray
Ribbon Leader
Lift up
Supply Roller
Notches
Ribbon Guide
110635_H