Safety Messages To Installers - Federal Signal 154XST Serie Instrucciones De Instalación Y Mantenimiento

Safety Messages to Installers

It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is thoroughly
familiar with the National Electrical Code and/or Canadian Electrical
Code and will follow the NEC and/or CEC Guidelines as well as all
local codes. This beacon should be considered a part of the warning
system and not the entire warning system.
The selection of the mounting location for the beacon, its controls
and the routing of the wiring are to be accomplished under the
direction of the facilities engineer and the safety engineer. In
addition, listed below are some other important safety instructions
and precautions you should follow:
• Read and understand all instructions before installing or
operating this beacon.
• Never alter the unit in any manner. Safety in hazardous
locations may be endangered if additional openings or other
alterations are made to units specifically designed for use in
these locations.
• Do not connect this light to the system when power is on.
• Keep the beacon tightly closed when in operation.
• After installation, ensure that the set screw is properly
tightened and that threaded joints are fully engaged.
• After installation, test the light system to ensure that it is
operating properly.
• After testing is complete, provide a copy of this instruction
sheet to all operating personnel.
• Establish a procedure to routinely check the light installation
for integrity and proper operation
Failure to follow all safety precautions and instructions may result
in property damage, serious injury, or death.
Installation and Maintenance Instructions
Models 154XST and 154XST-S
5