Mounting The Speaker - Master audio CS6/T Manual Usuario

Master Audio
• Avoid interference from neighbouring electrical appliances that may adversely
influence signal quality
• Position your Master Audio ceiling speaker away from moisture, excessive sunlight
and dust
3.1. Choosing the best location
Ideally, locate the speakers above the main listening area. Before doing so, be sure
that:
• The desired location is free of obstructions, such as electrical piping, AC ducts or
water lines
• There is enough space behind the mounting surface for the speakers
• Rear side of the speaker is not blocked by wall studs or other objects
3.2. Cutting the ceiling tile
To cut the ceiling tile, do the following:
• Remove the paper circle in the supplied template
• Mark the opening in the correct location by tracing the hole in the template
• Cut out the hole according to the template or with a circular cutter set to the
appropriate cut-out size. Initially, you can cut a smaller area inside the marked hole
just to be sure that the space above the speaker is clear

3.3. Mounting the speaker

To install the ceiling speaker, do the following:
• Remove the grille
• Connect the speaker wires to the appropriate connector terminals
• Push the speaker into the ceiling hole until the front baffle rim is levelled with the
ceiling
• Tighten the mounting tabs by turning the screw counter clockwise. When tightening
the mounting tabs, the tabs automatically turn outward, thus clamping the speaker
to the wall from its rear side. Do not over-tighten the screws as it may cause
damage to both the speaker and the surface.
CS Series. Version 1.0 Mar14 8