Tool-Less Wing Lock (Pt Hardware) - Permobil BODILINK Guía De Usuario

INSTALLATION - ADDING LINKS, WING LOCK

Tool-Less Wing Lock (PT Hardware)

Note: The taper inserts may be oriented so screws and wing locks face either left or right.
1
In the joint you will be replacing with a wing lock: Remove the screw (A) and the safety washer
(B) from the taper insert (C).
2 Remove the threaded half of the taper insert (C) and replace with the threaded end from the
wing lock (D). Make sure the square ends of (D) and the countersunk end of (C) are aligned
inside for a low-profile fit in the joint.
3
Insert the wing lock (E) and the safety washer (F) into the taper insert (C) half and tighten.
Firmly hold the wing lock (D) while tightening.
CAUTION (Step 4): The retainer clip is very difficult to remove once installed. Adding the
retainer clip to the wing lock assembly should be considered a permanent change.
4 To add the retainer clip: With the convex side facing out, align the retainer clip (G) with the tip
of wing lock (E) and press on firmly.
5
Repeat steps 1 through 4 for each joint being replaced with a wing lock.
Threaded End
C
BodiLink Head Support User Guide & Manual
B
A
14
D
Countersunk End
C
D
G
F
E
E