Bartscher 110 Serie Instalación Uso Y Mantenimiento página 41

Maintenance
ATTENTION! Before doing any kind of maintenance or repairs, make sure that the
appliance is disconnected from the electric mains and that the gas cutoff valve is closed.
The following maintenance operations must be carried out at least once a year by specialized
personnel. It is advisable to have a maintenance contract.
x Check for correct functioning of all control and safety devices;
x Check for correct ignition of burners and proper functioning at minimum;
x Check the thightness of the gas pipes;
x Check the condition of the power cable;
x The gas tap should be lubricated but this is a difficult operation and not very reliable; therefore
it is advisable to substitute it.
Informations for electrical and electronic devices used in EU countries
The devices which are marked with the following symbol may not be disposed of with
household refuse in accordance with the EU directive.
To eliminate your used device, please use the country-specific differentiated collection systems
available to you, or contact your retailer when you buy an equivalent device.
By actively using the offered collection systems, you make your contribution to the reuse, recycling
and utilisation of electrical (electronic) devices, protecting the atmosphere and the health.
SUBSTITUTING COMPONENTS
ATTENTION! Before carrying out any substitutions, make sure that the appliance is
disconnected from the electric mains and that the gas cutoff valve is closed.
Safety Thermostat
To substitute the thermostat, it is necessary to remove the knobs, the drip pan and the control panel,
as shown in figure 8; then the bulb situated in the front part of the appliance, may be taken out,
removing the fixing plate of the bulb (1) by unscrewing the appropriate screw (2). Next, it is
necessary to unscrew in sequence, the pipe union of the pipe which goes to the burner (3), the pipe
union of the pilot burner pipe (4), the thermocouple (5) and finally, the pipe union of the ramp (6).
Then substitute the part.
Thermocouple
To substitute the thermocouple of the fry-top, it is necessary to remove the knobs, the drip pan and
the control panel. It is then necessary to unscrew the fitting of the thermocouple on the cock and the
one on the pilot unit, then substitute the part.
Pag. 40/66